How to create a 3D jewellery set
What you will need:
Results – These can be distinct primarily based on private choices:
Resources:
Guidelines:
- Initial you will require to noticed/file the sprue off the components
- You can pre buff/ pre polish the star parts which would make cleaning less complicated soon after soldering
- Working with buff sticks to buff again the forged end going from coarse to fine
- The moment you have obtained to wonderful buff paper you can start off to polish utilizing luxi compound –blue for 1st stage with the calico mop
- There are guideline marks on the place of the star pendant and earrings you want to solder jump rings to
- You can file soar rings with triangular file to give them an angle at the ends so they sit flat from the point of the star
- Implement solder paste exactly where the tutorial marks are on the stars
- On the soldering block, push the jump ring towards the stars manual marks and use tweezers to keep the leap ring in position
- Using the hand torch, heat up the stable star and after it is setting up to turn color little by little move along to the bounce ring so it receives to tempreture at very same time until the solder melts and joins the pieces with each other
- Quench and put it in pickle, rinse soon after pickling to clean off acids.
- If you didn’t buff and pre polish formerly now you will will need to buff back again the solid end and if you have to have to eliminate any extra solder
- Polish the piece using luxi compound – blue for initial phase utilizing a calico mop
- Then polish with White luxi compound and a fluffy mop
- For your earrings you can open up your ear wire and then shut it back again alongside one another
- For the star pendant necklace, dependent on the bail you select you can possibly increase it right the the leap ring or if needed you may need to insert a different lesser jump ring before the bail.
- Ultrasonic or clear off any residual polish and include a chain to the pendant.
Optional: you can both fully near your results by soldering them throughout soldering phase 9 or depart the results semi open and just pushed with each other .
